The Sonex® Acoustic Panel Adhesive has been specially formulated for use with our Sonex® acoustic foam panels. One 10.5-ounce tube installs approximately 16–24 square feet of Sonex® acoustic foam wall panels and fits into a standard caulking gun.

This non-toxic, water-based adhesive makes installation hassle-free and provides a strong, permanent bond when adhering Sonex® melamine materials to walls or ceilings. Compatible with Sonex® Panels in both polyurethane and melamine foams. Sonex® Acoustic Panel Adhesive provides easy clean-up with water.

Features

• Non-flammable
• Quick tack time
• Water-resistant
• Odorless
• Non-toxic

Technical Information

• Size: 10.5-ounce tube
• Coverage: Approximately 16–24 square feet per tube
• Part Number: PA-02
• Storage and disposal: PROTECT FROM FREEZING. Store in a cool, dry place at room temperature. For maximum shelf life store at 75º F (24º C). Take unwanted product to an approved household hazardous waste transfer facility. Hardened material may be disposed of with trash.

Installation Method

• Ensure all surfaces are clean, dry, structurally sound, and free of dust, grease, oil, or other debris. During installation, be sure to maintain a constant room temperature.
• Sonex foam panels can easily be mounted to any wall or ceiling surface with acouSTIC water-based adhesive and a standard caulking gun.
• Follow instructions on the back of tube.
• Installation is best done at the end of the construction project.
• Use clean gloves to prevent soiling material.
• Melamine foam is fragile and should be handled with care.
• Do not install material of unacceptable quality.
• Cut nozzle at a 45-degree angle to allow for a 1/4" bead of adhesive.
• Puncture the seal in the base of the nozzle.
• Apply 1/4" bead of adhesive around the perimeter of the panel approximately 1" from the edge.
• Next apply a 1/4" bead of adhesive from opposite corners through the center of the panel to form an 'X'
• Press panel firmly into place. Then pull panel away from the wall for approximately one minute to allow adhesive to become tacky.
• Press the panel into its final position applying light pressure over adhesive areas.
• Installation overhead or onto metal substrates may require additional support and cure time for adhesive to set.