School of Rock
Liberty Screening Room
Woodberry Forest School
Old Mill Kennel
Ecole Bilingue de Berkeley
Diamond Credit Union
Sonex® Acoustic Panel Adhesive
The Sonex® Acoustic Panel Adhesive has been specially formulated for use with our Sonex® acoustic foam panels. One 10.5-ounce tube installs approximately 16-24 square feet of Sonex® acoustic foam wall…
Loctite® Power Grab Adhesive
Loctite® Power Grab Adhesive is a non-toxic water-based adhesive that makes installation quick and easy by providing a strong permanent bond when applying acoustic panels and ceiling tiles to walls…
Sonex® Audio Tiles
Sonex® Classic Foam
Loctite® Spray Adhesive comes in 13.5 oz. aerosol cans and is ideal for attaching acoustic foam to surfaces such as drywall, wood, plastics, cardboard, and most metals. When using this spray adhesive, you apply to it both the installation surface as well as the acoustic material. Once both surfaces are covered, the adhesive will get tacky, and hold together when firmly pressed against each other. Each can will cover 200 square feet total, which equals 100 square feet of installed product.
Well-ventilated area, wash hands after use.
Shake well before using. Apply adhesive between 65°F (18°C) and 95°F (35°C). Shake can well before using. Surfaces must be clean, dry and free of foreign materials. Protect finished surfaces. Pre-fit all materials. Testing of substrates for compatibility is recommended. Re-positioning is not possible. Turn spray tip so that the black dot is aligned with the nozzle.
Hold can in a vertical position. Point valve towards surface and spray from a distance of 8” to 10” (20 to 25 cm). Keep the can moving to create an even coat and avoid build-up on the surface. Start and stop the spray just off the work to prevent runs and sags. Apply an even coat to both surfaces to be bonded and allow to dry 2 to 5 minutes between coats. Apply maximum pressure over entire surface. Adhesive loses tack after approximately 10 minutes. Re-coat if time exceeded. Porous surfaces will require more than one coat.
After use, invert spray can and spray for approximately 2 seconds (or until spray is free of adhesive) to clear valve and spray tip. Clean spray tip with turpentine or mineral spirits. Note: When using solvents for cleanup, use proper precautionary measure. DISCLAIMER: The information and recommendations contained herein are based on our research and are believed to be accurate, but no warranty, express or implied, is made or should be inferred. Purchasers should test the products to determine acceptable quality and suitability for their own intended use. Nothing contained herein shall be construed to imply the nonexistence of any relevant patents or to constitute a permission, inducement or recommendation to practice any invention covered by any patent, without authority from the owner of the patent.